Ottomatics Inc. Machine List

Notes

Two machines available from the same facility in the southeast; the other serial is 1,790,969 and is a double feed machine new in 1960 - machine was rebilt in 1989 at a cost of $70,000 each. ||Photographs are available Immediately upon request. All the tooling is included.|Machine equipped with: (approximately)3 Knee tools, 3 low roll supports - 2 high, 4 roller turners, 1 circle form, 1 shave, 2 low flat forms - 1 high, 2 cutoff holders, 4 auxilairy slide plates, 6 feed tubes, 18 sets of collets. Wired 480 volt, motors are dual voltage. Stem, gear box, fulcrum arms, back end, bronze gear, cross slides, all very good.|Machines were rebuilt by AMR Industries, 7725 S. 6th St., Oak Creek, WI 53154.