I want to sell a machine like this
- CNC Machine
- Escomatic
- 643D
- Lathe - CNC
- 6.4mm
- 2006
Notes
MINT CONDITION
2006 Esco NM 643D coil fed automatic lathe w/back working
Printed manuals
Original hand tools
Machine options:
Counter Collet with “C” axis (pick-off and Back
working)
Losma mist collector
Automatic carousel w/12 containers
Losma roll filter sump w/automatic media
advance
Additional equipment:
1) Tool presetter
1) Torque screw-driver
1) Special 90 degree milling spindle
3) Standard back working spindle (mill/drill)
1) Drive belts for back working spindles
3) Feed collets (Ø.050in., Ø2mm, Ø.125in.) plus some spares.
3) Guide bushing (same as above)
3) Counter collet w/ejectors (same as above)
6) Tool holders
1) Habegger end-knurl holder (3 wheel type)
1) Stafford knurl
holder (2 wheel straddle type)
20+) Roll filter media (60 micron)
COST over $250,000 NEW was ran as a fill in for a product he
outsourced and then just sold the product line and kept the machine.
Machine is in pristine condition with low total part count. Under 5000 run hours.
Buyer is to verify the information is correct above.
If you require any further information, please call.