Ottomatics Inc. Machine List

Notes

FURTHER OPTIONS:
Hinge-type chip conveyor,
discharge height 950 mm
The type of chip conveyor used depends
on the chip material.
A hinge-type chip conveyor is normally
used for long-chipping materials and
woolly chips.
Coolant supply unit for externally and
internally cooled tooling, 20 l/min -
30 bar, for front and rear end machining
units
(requires 983125/983126)
Coolant filter system based on a
flatbed filter unit (without using
auxiliary materials)
Throughput:
approx. 100 l/min for emulsion
approx. 70 l/min for cutting oil
Retained particle size:approx. 50 micron
Tank capacity: approx. 400 litres
incl. inlet mixer baffle, belt feed
controlled by level switch or
intermittent feed switch.
When using cutting oil the viscosity
must not exceed ISO VG 10.
Flushing gun for machining area
Coolant mist extraction & filter unit,
electrostatic filter manufactured by
REVEN, fitted on top of machine cover;
air throughput approx. 800 m3/h;
filtered air recirculated to ambient
air. Electrical connection to machine
supply via plug connector.
885751 Pressure release hatch cpl.
Presetting aid for turret and quill-
mounted tools, mechanical
Software for counterspindle V axis;
counterspindle V axis is switched off
when the workpiece is transferred and
deposited in its target position on a
flat block
Preparing machine for future connection
to the integrated TRAUB Teleservice
system. Fitting a V24 analog modem in
the switchgear cabinet.
TRAUB supplementary software for
Y axis 3D helical interpolation
Rigid tapping
TRAUB Polyform supplementary software.
Easy programming for C axis milling;
contour input with geometry support
- on the face
- on the side
- on the circumferential surface of a
workpiece
FOR BAR WORK:
Installation components for fitting a
FMB turbo 5-42 bar loading magazine
with bar pusher dias. 15-25-32 mm;
incl. live reducing sleeves, adaptation
of panels and synchronous unit linkage;
sub-program as per catalogue
no. 946791 available from T-TKD1
FMB Barfeeding Magazine turbo 5-42
for connection to TRAUB TNL 26
FMB turbo 5-42
max. bar length 4200 mm
Standard equipment:
- Oil-flooded channel
- Side-mounted bar storage, 280 mm.
- Automatic retractor unit for removing
bar remnants up to 530 mm long.
- Bar infeed control unit.
- Profiled bar infeed control unit
- Guide steady incl. bar guide
- FANUC SPC control system
- Loading from front, bar feed from
right side.
- Adaptation to TNL26 (incl. anchor
bolts)
- Harting connector plug
- Excluding oil (capacity 80 litres
hydraulic oil ISO 150).
- Excluding guide channel
- Excluding bar guides.
- Excluding clamping sleeves.
Operating voltage 460V, 60 Hz, 2.0 KW
Control voltage 24 V DC (UL type for USA)
Compressed air supply: 6 bar
Colour:
Special paint finish dust grey RAL 7037
Auxiliary equipment:
Guide channel 25 mm dia. - 4200 mm
fitted with 25 mm dia. bar feed rod,
for bar diameters 12 - 23 mm (25)
Telescopic intermediate tube
(generally required)
Bar guide unit 20 mm dia.
for bar diameters 14.1 - 19 mm
Clamping sleeve SHT 25 mm dia./
max. bar dia. 23 mm
(ID increasing in 0.5 mm steps)
Synchronous unit